Methods: A total of 54 healthy eyes were enrolled in the study. This manual is intended to serve as a guide for co- management of cataract patients. The iTrace wavefront aberrometry of cornea calculated steep power and axis based on the best Zernike mathematical fit from all topo data within 4 mm circle. Itrace: read memory (174712 bytes), each dot denotes 2048 bytes: Purpose: To compare and evaluate the total and internal aberrations measured by two aberrometers: the laser ray tracing aberrometer (iTrace, Tracey Technology) and the automatic retinoscope aberrometer (OPD Scan, Nidek). Background Currently, there is no standard technique for determining corneal astigmatism. This option is useful for debugging itrace it dumps the contents of the trace buffer in row format. By default, animation is enabled.ĭumps the trace buffer and exits. Sets the itrace not to animate the propeller in wait mode (-w option). Use memory mapping to access trace buffer. If the cr-space device specified by the -d parameter is one of the I2C devices, -nomap is switched on. By default, itrace accesses the memory directly. 5 Turn on the power on the iTrace DAU (set-up instructions provided in the companion iTrace Quick Setup Guide and in Appendix C of this manual). Sets the itrace to not access memory directly (via memory mapping) for reading the trace buffer, but to use the adapter memory access Gateway instead. To run itrace via the I2C interface, use this option to specify the following: -d=DEVICE, where the device is an I2C device (such as mtusb-1) The default value is:/dev/mst/mt4099_pci_cr0. Specifies the name of the mst device driver for accessing the cr-space. Without the -w option, itrace will exit if there have been no new traces in the last 0.5 seconds. This is not the default behavior of itrace. Start the mst driver (mst start or mst restart).The mst driver must be started prior to running itrace tool. The desired trace mask is set (see the -m flag below) The iTrace uses this fundamental principle of Ray Tracing where a sequential series of infrared beams on the order of 100 microns and a 785 nm wavelength each.For adapters without on-board memory (MemFree): The RUN_FW command has been executed.For adapters with on-board memory: The SYS_ENABLE command has been executed.Debug firmware is burnt and loaded on the device.In order to print the firmware traces, the following are required: It prints trace messages in text format to the console. The utility is a command line application controlled by command line parameters. The trace buffer is located in host memory for MemFree adapter cards (i.e., without on-board memory), and in adapter memory for adapter cards with on-board memory. Trace messages generated by iRISCs are stored in the trace buffer. These trace messages inform developers of software drivers about internal status, events, critical errors, etc., for each iRISC. The itrace utility extracts and prints trace messages generated by the firmware of a ConnectX-2/ ConnectX-3/ConnectX-3 Pro adapter cards.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |